Step #1: After launching, you'll see this dialog. It should be noted that when you run it you'll still be presented with a dialog which makes you think it didn't work, but this is just giving you the opportunity to either run wireshark as yourself, "unprivileged", or as root. Do not select 'Install Npcap in WinPcap API-compatible Mode' this selection is not compatible with the load balancer. If you need to capture packets on the loopback interface, select 'legacy loopback support' during the npcap installation. ![]() These are the basic 3 steps to install wireshark software in RedHat Linux. Once you've made the above changes you can now launch wireshark. Wireshark does not capture any packets on Windows 10 unless NpCap is updated to version 1.0 or higher. How to Install Wireshark in RedHat Linux. NOTE: It should be noted here that after making the above changes you'll need to logout and log back in so that the new group gets picked up by your username. $ setcap cap_net_raw,cap_net_admin=eip /usr/sbin/dumpcap You need to perform the following steps to allow non-root users access to the dumpcap file so that they can open it for use within tshark/wireshark. ![]() The Amazon AMI images are based on CentOS images and so the steps I outlined in that answer should apply here as well. RedHat 8 comes with Lua 5.3 and I understand that is not supported, however, I have built Lua 5.2. ![]() See my answer to this other U&L Q&A titled: “tshark: There are no interfaces on which a capture can be done” in Amazon Linux AMI.
0 Comments
Leave a Reply. |